 |
Intro to Breadboard Electronics
Posted by: makemagazine
Video duration: 300 seconds
Global video hits: 153817
In this podcast, Bre Pettis shows you how to set up a breadboard for power and then play around with electronics on it Note: In the podcast, I mention Charles Platt's article is from Make: volume 11. Its actually in Make: Volume 10.
Related: makezine, make, howto, diy, instructions, podcast, bre, pettis, breadboard, electronics, introduction, get, started, gadgets, oreilly, science, technology, how-to, art
Display Video Comments | Hide Video Comments | Add Comment
|
|
 |
Collin's Lab: Electronics Tools
Posted by: makemagazine
Video duration: 567 seconds
Global video hits: 88614
bit.ly Get geared up for circuit-making- check out Collin's list of tools no electronaut should be without!
Related: electronics, tools, diy, circuits, soldering, hand tools, hacking, making, list, gear, building, pliers, make magazine, collin cunningham
Display Video Comments | Hide Video Comments | Add Comment
|
|
 |
EEVblog #168 - How To Set Up An Electronics Lab
Posted by: EEVblog
Video duration: 1629 seconds
Global video hits: 59056
Most items available through HERE: www.eevblog.com How to set up your own decent electronics lab, what you need, and how much it'll cost you. Electronics test equipment, soldering, surface mount, hand tools, and parts. Help support Dave by buying any of these items through the link above.
Related: electronics, lab, workshop, howto, setup, equipment, soldering, iron, station, smd, surface, mount, microscope, inspection, pcb, oscilloscope, multimeter, function, generator, pliers, cutters, hand, tools, screwdrivers, bread, board, vero, strip, wire, cable, desoldering, reflow, hot, air, glue, electrical, tape, gaffa, duct
Display Video Comments | Hide Video Comments | Add Comment
|
|
 |
EEVblog #281 - BK Precision 8500 Electronic Load Teardown
Posted by: EEVblog
Video duration: 1323 seconds
Global video hits: 9288
www.bkprecision.com Featured Chips: AD7708: www.analog.com DAC7631: www.ti.com ADR421: www.analog.com IRFP250N: www.irf.com Teardown Tuesday. What's inside BK Precision's 8500 300W 120V/30A DC Electronic Load? It is also known as the Itech 8512. www.itech.sh Dave's DIY Simple Constant Current Dummy Load: www.youtube.com
Related: bk, precision, itech, dc, electronic, load, 300w, it8512, mosfet, diy, constant, current, power, resistance, voltage, dummy
Display Video Comments | Hide Video Comments | Add Comment
|
|
 |
EEVblog #280 - Talking Electronics - Old Hardware - Part 5 of 5
Posted by: EEVblog
Video duration: 683 seconds
Global video hits: 7613
PART 1: youtu.be PART 2: youtu.be PART 3: youtu.be PART 4: youtu.be PART 5: youtu.be www.talkingelectroni cs.com Part 5 of an interview with Colin Mitchell, the pioneering founder of Talking Electronics magazine. In this final part he takes us through some old hardware kits, including the TEC-1 and Microcomp computers.
Related: colin, mitchell, talking, electronics, magazine, australia, australian, industry, electronics australia, interview, documentary, diy, printing, pcb, kit, publishing, advertising, tec, computer, zilog, z80, microcomp, chip, solder, learning
Display Video Comments | Hide Video Comments | Add Comment
|
|
 |
EEVblog #280 - Talking Electronics - History - Part 1 of 5
Posted by: EEVblog
Video duration: 2269 seconds
Global video hits: 9481
PART 1: youtu.be PART 2: youtu.be PART 3: youtu.be PART 4: youtu.be www.talkingelectroni cs.com Part 1 of an interview with Colin Mitchell, the pioneering founder of Talking Electronics magazine, which was immensely popular in the 1980's in Australia.
Related: colin, mitchell, talking, electronics, magazine, australia, australian, industry, electronics australia, interview, documentary, diy, printing, pcb, kit, publishing, advertising
Display Video Comments | Hide Video Comments | Add Comment
|
|
 |
EEVblog #280 - Talking Electronics - America - Part 2 of 5
Posted by: EEVblog
Video duration: 950 seconds
Global video hits: 4641
PART 1: youtu.be PART 2: youtu.be PART 3: youtu.be PART 4: youtu.be www.talkingelectroni cs.com Part 2 of the interview with Colin Mitchell from Talking Electronics. In this one he talks about moving Talking Electronics Magazine to America, and the deal with and demise of Poptronics magazine.
Related: talking, electronics, magazine, interview, documentary, history, colin, mitchell, poptronics, america, usa, newsagents, book, stores, distribution, barnes, and, noble, amazon, church, subscription, pic, chip, programming, assembly, chinese, alcohol, detector, kit
Display Video Comments | Hide Video Comments | Add Comment
|
|
 |
EEVblog #280 - Talking Electronics - The Internet And Learning - Part 4 of 5
Posted by: EEVblog
Video duration: 433 seconds
Global video hits: 3188
PART 1: youtu.be PART 2: youtu.be PART 3: youtu.be PART 4: youtu.be PART 5: youtu.be www.talkingelectroni cs.com Part 4 of an interview with Colin Mitchell, the pioneering founder of Talking Electronics magazine. In this part he talks about the internet, learning electronics, and forums.
Related: colin, mitchell, talking, electronics, magazine, australia, australian, industry, electronics australia, interview, documentary, diy, printing, pcb, kit, publishing, advertising, internet, learning, teaching, books, forums, comment, opinion, forum
Display Video Comments | Hide Video Comments | Add Comment
|
|
 |
EEVblog #280 - Talking Electronics - FM Bug Kits - Part 3 of 5
Posted by: EEVblog
Video duration: 712 seconds
Global video hits: 3469
PART 1: youtu.be PART 2: youtu.be PART 3: youtu.be PART 4: youtu.be www.talkingelectroni cs.com Part 3 of an interview with Colin Mitchell, the pioneering founder of Talking Electronics In this part he talks about the famous FM bug kits, and train kits, and the kit business.
Related: colin, mitchell, talking, electronics, magazine, australia, australian, industry, interview, fm, bug, fm bug, model, train, controller, kit, diy, printing, pcb, publishing, advertising
Display Video Comments | Hide Video Comments | Add Comment
|
|
 |
Ampere - A to Z of Electronics
Posted by: jeriellsworth
Video duration: 294 seconds
Global video hits: 38742
Ampere is a unit of measurement for current and was named after André-Marie Ampère. This video was generously sponsored by www.adafruit.com Thanks to www.cdef.com.br for translating to Portuguese.
Related: ampere, amps, current, electricity, electronics, test and measurement, volt meters, vom, ohms law, jeri ellsworth, adafruit
Display Video Comments | Hide Video Comments | Add Comment
|
|
 |
Sketching Electronics
Posted by: buechley
Video duration: 108 seconds
Global video hits: 340130
Related: sketching, electronics, high-low, tech, leah, buechley, jennifer, lewis, conductive, pen, teardrop, arduino, paper, computing
Display Video Comments | Hide Video Comments | Add Comment
|
|
 |
iHeart Electronics - iPhone Mod!
Posted by: thebenheckshow
Video duration: 992 seconds
Global video hits: 24417
In the spirit of CES, Ben builds a mod for the ever-popular consumer electronic device, the iPhone. Never Miss An Episode- Subscribe For More of The Ben Heck Show: www.youtube.com Watch more episodes of The Ben Heck Show here: www.youtube.com Like The Ben Heck Show on Facebook: www.facebook.com Follow Ben on Twitter: www.twitter.com
Related: epilog laser engraver, buttons, 3d, 3d printer, acrylic, smellavision, bluetooth, ipod dock, usb, vcc, iphone, ipad, icade, controls, baby monkey, iphone mod, mods, gaming mods, controller, ben heck, the ben heck show, ben heckendorn, apple, ios
Display Video Comments | Hide Video Comments | Add Comment
|
|
 |
Robotics and Electronics Tutorial - 8 - Resistor Color Bands
Posted by: thenewboston
Video duration: 350 seconds
Global video hits: 72843
Part 9 - www.youtube.com How to use the colored bands on your resistor to calculate their value.
Related: robotics, robot, electricity, resistors, ohms, digital, choose, how, to, learn, tech, cool, resistor, build, tutorial, make
Display Video Comments | Hide Video Comments | Add Comment
|
|
 |
Awesome Electronics Workshop LCD and GPS
Posted by: makemagazine
Video duration: 315 seconds
Global video hits: 311922
Bre Pettis teams up with Hardware Hacker Joe Grand to show you how to integrate LCDs and GPS into your electronics projects. Then they put these two things together on a basic stamp and create a portable GPS tracking system and go geocaching!
Related: makezine, joegrand, brepettis, lcd, gps, electronics, howto, instructions, diy, componenets, fun, geocaching, make, gadgets, oreilly, science, technology, how-to, art
Display Video Comments | Hide Video Comments | Add Comment
|
|
|
|
Golf Related VideosYou like it? Share it!
Social Bookmarking 
|
Latest comments made on this video:
By: AcesHighProd. on 24 May 12, 12:43:22
smart? girl!
By: spacemouse1. on 24 May 12, 12:23:08
I'm still trying to build? a working Time Machine >>0
By: spacemouse1. on 24 May 12, 12:20:18
I? think you are beautiful !!
By: HushamSamirNSN. on 15 May 12, 21:20:51
Impressive vedio, nice work!!!!?
By: tlmcqu80. on 10 May 12, 02:25:50
too? cool!!!! I want to get started...
By: bob3006. on 06 May 12, 01:28:19
Poppa Chicken was a jerk?
By: danszimmy07. on 04 May 12, 19:25:21
thank you for your honest approach to electronics and? kind words, you allow people who are scared to attempt electronics feel at ease, so for that, thank you! hope for your continued success!
By: Aussie533. on 27 Apr 12, 04:10:14
You are? clever and a beaut. Good on you.
By: Nilguiri. on 21 Apr 12, 12:48:33
Don't pick up giant chickens.? Got it.
By: whiskeyify. on 18 Apr 12, 22:19:30
I fooled around on my own...I'd pull tv's out of the trash and try to fix them. Eventually at age 47 I got job in a eletronic repair shop. You have to be careful when working on customer's stufff and if your break something you might get fired. So get lots of? practice on some junk equipment first.
By: radiofun232. on 12 Apr 12, 18:41:29
Thanks for this video. (*****). I made it one of my favorites. In 1967 I bought my first transistor (OC 13, germanium). Components were too expensive then and I? had to salvage components from old equipment for many years. And, yes, mistakes are inherent to electronics and only after a some years of experiments the "insight" in what really happens will come. Advise to anyone interested in electronics: buy an oscilloscope! You will speed up your experience.
By: fucktopyo. on 11 Apr 12, 23:41:30
4:03? last atempt with a man oups
By: pouelchnu. on 08 Apr 12, 13:09:35
Well, I think you've got yourself a new subscriber. I am graduating in? electrical engineering next year and I can relate to what you say. Good job posting those videos. I'm now off to watch the PLL episode.
By: psyaztra. on 06 Apr 12, 20:36:58
i love? i love i love
By: shualiko. on 06 Apr 12, 14:26:03
This is absolutely great and? funny and true. Thank you. :-)
By: CNLohr. on 02 Apr 12, 04:36:12
I can't believe I am seeing this right now. About a year ago, I came to the same? conclusion. And it's exactly what I tell people. Who cares if it's useful, who cares if it works well. What matters is you're learning now, and soon, you'll be doing things no one has ever done.
By: kerimil. on 28 Mar 12, 18:09:56
damn gir...l will you? marry me??
By: curemymind. on 28 Mar 12, 07:25:42
I fail all the time but i do? make few things work out... I guess without me failing a lot and i mean a lot, i wouldn't know the things i know today :).... nice video...
By: sperooo. on 25 Mar 12, 11:29:16
i? am 20 years old :( ... i am old :( :( :(
By: tommeasor. on 25 Mar 12, 11:21:17
Started in electronics 50 years ago, messing about with valves (tubes).? Love it.
By: greenaum. on 24 Mar 12, 21:18:40
Oh god, I'm in love with Jeri Ellsworth. I? always thought it might happen, from reading about her, but now I've seen her face and heard her voice, and her very cool philosophy of life, way of thinking, calm eloquence, and cuteness. Oh dear me.
By: craig265. on 24 Mar 12, 04:38:20
Im 42 and it didnt? get better
By: MakeMeAPizza01. on 24 Mar 12, 02:47:54
married??
By: kdc43. on 23 Mar 12, 07:09:25
Apparently, Thomas Edison got reincarnated as? a smart girl.
By: shadowC10ne. on 22 Mar 12, 17:17:48
Subbed! :)?